IECS-1116 Series User Manual

16
6. Getting Started
Thischapterprovidesabasicoverviewofhowtocongureandoperate
your IECS-1116 series.
6.1 Connecting the Power and the Host PC
Step 1: Connect both the IN port of the IECS-1116 Module and RJ45
Ethernet port of Host PC.
Ensure that the network settings on the Host PC have been correctly
congured and are functioning normally. Ensure that the Windows
rewall and any anti-virus rewall is properly congured to allow
incomingconnections;ifnot,temporarilydisablethesefunctions.
Note
Attaching an ESC (EtherCAT Slave Controller) directly to
an office network will result in network flooding, since
the ESC will reflect any frame – especially broadcast
frames–backintothenetwork(broadcaststorm).
Step 2: Apply power to the IECS-1116 module
V+
GND
V+
+
9-48V DC
PC
IN
Connect the Host
device to the IN Port on
IECS-1116 module.
Connect the V+ pin to positive
terminal on a 9-48V DC power
supply, and connect the V- pin to
the negative terminal.