IFT-80x Series User Manual

14
2.1.4 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of
Industrial Media Converter is used for two DC redundant powers
input. Please follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into the contacts 1
and 2 for POWER 1, or 5 and 6 for POWER 2.
V1- V1 + V2 - V2 +
2. Tighten the wire-clamp screws for preventing the wires from
loosing.
1 2 3 4 5 6
Power 1 Fault Power 2
- + - +
Note
The wire gauge for the terminal block should be
in the range between 12 ~ 24 AWG.