IGS-5225 Series User Manual

Command Guide
-132-
Default:
Disable
Usage Guide:
To enable SSM of SyncE for specific interface
Example:
To enable SSM of SyncE for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # network-clock synchronization ssm
4.2.65.71 no
Command:
no
no Negate a command or set its defaults
Default:
N/A
Usage Guide:
To default the function for specific interface
Example:
To enable the function (network-clock synchronization ssm) for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # no network-clock synchronization ssm
4.2.65.72 ping ip
Command:
ping ip <ipv4_addr> size <size: 2-1452>
ping The ping command allows you to test connectivity to a network host from the appliance
ip ip
<ipv4_addr> IP address
size size