User Manual

21
1. Set the DIP Switch of SFP Port 1 or Port 2 to the “OFF” position with
ber speed 1000Base-X.
ON OFF
Port 5 (DIP 1) 100FX 1000X
Port 6 (DIP 2) 100FX 1000X
2. Make sure both sides of the SFP transceiver are with the same media
type, for example: 1000Base-SX to 1000Base-SX, 1000Base-LX to
1000Base-LX.
3. Check whether the ber-optic cable type matches with the SFP trans-
ceiver model.
To connect to 1000Base-SX SFP transceiver, use the Multi-mode
ber cable, with one side being the male duplex LC connector type.
To connect to 1000Base-LX SFP transceiver, use the Single-mode
ber cable, with one side being the male duplex LC connector type.
Connecting the ber cable
1. Insert the duplex LC connector on the network cable into the SFP
transceiver.
2. Connect the other end of the cable to a device switches with SFP
installed, ber NIC on a workstation or a Media Converter.
3. Check the LNK/ACT LED of the SFP slot on the front of the Industrial
Gigabit Ethernet Switch. Make sure that the SFP transceiver is oper-
ating correctly.
100Base-FX:
Before connecting the other switches, workstation or Media Converter,
please do the following:
1. Set the DIP Switch of SFP Port 1 or Port 2 to the “ON” position with
ber speed “100FX”.
ON OFF
Port 5 (DIP 1) 100FX 1000X
Port 6 (DIP 2) 100FX 1000X