User Manual

29
Installation Steps
Step 1: Unpack the Industrial Gigabit Ethernet Switch.
Step 2: Check whether the DIN-Rail is screwed on the Industrial
Gigabit Ethernet Switch. (Please refer to DIN-Rail Mounting
section for DIN-Rail installation if the DIN-Rail is not screwed
on the Industrial switch). If you want to wall mount the
Industrial Gigabit Ethernet Switch, then please refer to
the Wall Mount Plate Mounting section for wall mount plate
installation.
Step 3: To hang the Industrial Gigabit Ethernet Switch on the DIN-Rail
track or wall, please refer to the Mounting Installation
section.
Step 4: Power on the Industrial Gigabit Ethernet Switch. (Please refer
to the Wiring of the Power Inputs section for power input)
The power LED on the Industrial Gigabit Ethernet Switch will
light up. Please refer to the LED Indicators section for the
functions of LED lights.
Step 5: Prepare the twisted-pair, straight through Category 5 cable
for Ethernet connection.
Step 6: Insert one side of Category 5 cables into the Industrial
Gigabit Ethernet Switch Ethernet port (RJ-45 port) while
the other side of category 5 cable to the network devices’
Ethernet port (RJ-45 port), eg. switch, PC or Server. The UTP
port (RJ-45) LED on the Industrial Gigabit Ethernet Switch will
light up when the cable is connected with the network device.
Please refer to the LED Indicators section for the functions of
LED lights.
Step 7: When all connections are all set and LED lights all show
normally, the installation is complete.
Note
Make sure the connected network devices support MDI/
MDI-X. If it does not support, then use the crossover
category 5 Cable.