User Manual

2.2.3 Fiber Installation

IGTP-802T/IGTP-802TS 1000BASE-X Installation:

To install an Industrial 802.3at PoE Media Converter stand-alone, on a

Track or wall mount, simply complete the following steps:

Step 1: Turn off the DC power of the device/station in a network to

which IGTP-802T/IGTP-802TS will be attached.

Step 2: Ensure that there is no activity in the network.

Step 3: Attach ber cable from the Industrial 802.3at PoE Media

Converter to the ber network. TX, RX must be paired at

both ends.

Step 4: Connect the DC power to the IGTP-802T/IGTP-802TS and

verify that the Power LED lights up.

Step 5: Turn on the power of the device/station; the PWR LED

(Green) should light when all cables are attached.

Location A Location B

PoE IP Camera

Fiber Switch

SFP Module

DC 12~48V, AC 24V

RJ45

Figure 2-4: IGTP-802T/IGTP-802TS Stand-alone Installation

Note

Please refers to APPENDIX-A for detailed wiring infor-

mation of the Industrial 802.3at PoE Media Converter.

To prevent from optic acceptor malfunction, check the

both wires / transmitter before power on the Industrial

802.3at PoE Media Converter.