User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. HARDWARE INSTALLATION
- 3. INDUSTRIAL MODBUS GATEWAY MANAGEMENT
- 3.1 Overview
- 3.2 Requirements
- 3.3 Management Methods
- 3.4 PLANET Smart Discovery Utility
- 3.5 PLANET Modbus Gateway Utility
- 3.5.1 Installing PLANET Modbus Gateway Utility
- 3.5.2 PLANET Modbus Gateway Utility Menu Bar
- 3.5.3 PLANET Modbus Gateway Utility Shortcut Menu Bar
- 3.5.3.1 User Manager
- 3.5.3.2 Import Network Topology
- 3.5.3.3 Export Network Topology
- 3.5.3.4 Zoom In
- 3.5.3.5 Zoom Out
- 3.5.3.6 Search Device
- 3.5.3.7 Save Topology
- 3.5.3.8 Delete Topology
- 3.5.3.9 Batch IP Settings
- 3.5.3.10 Batch Monitoring IP Settings
- 3.5.3.11 Hide Device Tree/Show Device Tree
- 3.5.3.12 Hide Alarm List/Show Alarm List
- 3.5.3.13 Auto Refresh Topology
- 3.5.3.14 Refresh Interval
- 3.5.4 PLANET Modbus Gateway Utility Device Function
- 4. WEB MANAGEMENT
- 5. COMMAND LINE INTERFACE
- 6. COMMAND LINE MODE
- APPENDIX A
User’s Manual of IMG-110T
-15-
2.1.5 Hardware DIP Switch for Reset to Default
The upper panel of the Industrial Modbus Gateway consists one 4-bit DIP switch for resetting the system to the factory default
mode.
■ Resetting to default through hardware DIP switch:
1: Find the hardware DIP switch that is near the RJ45 port of the Industrial Modbus Gateway.
2: Adjust DIP 2 at the “ON” position and DIPs 1, 3, 4 remain at the original position.
3: After adjusting the DIP switch, please power off and power on the Industrial Modbus Gateway to take effect.
After resetting the Industrial Modbus Gateway with the default IP address, and username and
password: admin, please adjust
DIP 2 to lower position. Otherwise, the Industrial Modbus Gateway will
continue to reset to the factory default mode.