User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. HARDWARE INSTALLATION
- 3. INDUSTRIAL MODBUS GATEWAY MANAGEMENT
- 3.1 Overview
- 3.2 Requirements
- 3.3 Management Methods
- 3.4 PLANET Smart Discovery Utility
- 3.5 PLANET Modbus Gateway Utility
- 3.5.1 Installing PLANET Modbus Gateway Utility
- 3.5.2 PLANET Modbus Gateway Utility Menu Bar
- 3.5.3 PLANET Modbus Gateway Utility Shortcut Menu Bar
- 3.5.3.1 User Manager
- 3.5.3.2 Import Network Topology
- 3.5.3.3 Export Network Topology
- 3.5.3.4 Zoom In
- 3.5.3.5 Zoom Out
- 3.5.3.6 Search Device
- 3.5.3.7 Save Topology
- 3.5.3.8 Delete Topology
- 3.5.3.9 Batch IP Settings
- 3.5.3.10 Batch Monitoring IP Settings
- 3.5.3.11 Hide Device Tree/Show Device Tree
- 3.5.3.12 Hide Alarm List/Show Alarm List
- 3.5.3.13 Auto Refresh Topology
- 3.5.3.14 Refresh Interval
- 3.5.4 PLANET Modbus Gateway Utility Device Function
- 4. WEB MANAGEMENT
- 5. COMMAND LINE INTERFACE
- 6. COMMAND LINE MODE
- APPENDIX A
User’s Manual of IMG-110T
-21-
3.4 PLANET Smart Discovery Utility
For easily listing the Industrial Modbus Gateway in your Ethernet environment, the Planet Smart Discovery Utility is an ideal
solution. The following installation instructions are to guide you to running the Planet Smart Discovery Utility.
1. Insert the attached user’s manual CD in the CD-ROM Drive.
2. Find and deposit the Planet Smart Discovery Utility in administrator PC.
3. Run this utility as the following screen appears.
Figure 3-9: Planet Smart Discovery Utility Screen
If there are
two LAN cards or above in the same administrator PC, choose a different LAN card by
using the “Select Adapter” tool.
4. Press the “Refresh” button for the currently connected devices in the discovery list as the screen shows below:
Figure 3-10: Planet Smart Discovery Utility Screen