User Manual
Table Of Contents
- Chapter 1. INTRODUCTION
- Chapter 2. HARDWARE INSTALLATION
- Chapter 3. INDUSTRIAL MODBUS GATEWAY MANAGEMENT
- Chapter 4. WEB MANAGEMENT
- Chapter 5. COMMAND LINE INTERFACE
- Chapter 6. COMMAND LINE MODE
- APPENDIX A
User’s Manual of IMG-120T
-31-
Figure 3-26: Planet Modbus Gateway Utility Tool Bar -- Set Timing Save Screen
Manual Add Device
This option allows you to manually set up IP search device and send search unicast packets; there are two ways
to manually add the device as shown below:
1: Add "On line Devices" under an existing IP address, click "√" in front of the desired IP address and click on
">" to add IP address;
2: A "Device IP Address" is filled out to manually enter the IP address and click "Add" to add the IP address.
Click OK for adding a unicast packet to search equipment. If the router's port mapping is configured, it can
implement search across route. Discovery process begins from PC Port 65533, Port 65534 sends commands to
the specified device, and then Port 65533 responds to a search and send confirmation to PC Port 65534 to
complete the search.