User Manual
Table Of Contents
- Chapter 1. INTRODUCTION
- Chapter 2. HARDWARE INSTALLATION
- Chapter 3. INDUSTRIAL MODBUS GATEWAY MANAGEMENT
- Chapter 4. WEB MANAGEMENT
- Chapter 5. COMMAND LINE INTERFACE
- Chapter 6. COMMAND LINE MODE
- APPENDIX A
User’s Manual of IMG-120T
-53-
setting the ID range and ID offset. Only the channel type in the slave mode of the channel can be set up, including
the Slave ASCII, Slave RTU and Slave TCP. Virtual ID + ID Offset = Real ID (Actual ID).
This function allows setting the value for slave ID configuration. Press the “Add” and “Submit” buttons to set the
value and the screen in Figure 4-7 appears.
Figure 4-7: Slave ID Screen
The page includes the following fields:
Slave ID Map Table
Channel No.
Display the channel number.
Channel Type
This parameter is to choose RTU Master/RTU Slave/ASCII Master/ASCII
Slave operation modes; the default mode is RTU Slave.
Channel Definition
Display the channel definition information.
Slave ID Range
(Virtual~~~Real)
Display the Slave ID Range information.