User Manual
Table Of Contents
- Chapter 1. INTRODUCTION
- Chapter 2. HARDWARE INSTALLATION
- Chapter 3. INDUSTRIAL MODBUS GATEWAY MANAGEMENT
- Chapter 4. WEB MANAGEMENT
- Chapter 5. COMMAND LINE INTERFACE
- Chapter 6. COMMAND LINE MODE
- APPENDIX A
User’s Manual of IMG-120T
-57-
Step 3: After setup is completed, press the “Affirm” button to take effect.
Figure 4-13: Slave ID Parameters Screen
Figure 4-14: Slave ID-ASCII Master Screen
The IP address of the TCP is 192.168.0.188 (For example, the IP address of the local PC), the TCP port number
is 6000, and the virtual ID is 3~4. Offset is 2.
ASCII Slave Mode
This function allows the users to use Modbus TCP master device and Modbus ASCII device to achieve
communication. The
operation mode of the gateway is set to ASCII Slave.
Step 1: Choose “ASCII Slave” in Channel Type.
Step 2: Press the “Modify” button to input the setting parameters.