User Manual
Table Of Contents
- Chapter 1. INTRODUCTION
- Chapter 2. HARDWARE INSTALLATION
- Chapter 3. INDUSTRIAL MODBUS GATEWAY MANAGEMENT
- Chapter 4. WEB MANAGEMENT
- Chapter 5. COMMAND LINE INTERFACE
- Chapter 6. COMMAND LINE MODE
- APPENDIX A
User’s Manual of IMG-120T
-69-
CHAPTER 6. COMMAND LINE MODE
The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the
CLI command modes are described below. Each of the command modes supports specific software commands.
After logging in and accessing the Industrial Modbus Gateway Telnet interface, please enter “?” or “help” under
Industrial Modbus Gateway Telnet interface where it displays a list of the available commands and descriptions of
the commands. The telnet commands list screen appears as Figure 5-3 shows.
Figure 6-1: Telnet Help Screen of Industrial Modbus Gateway
The page includes the following configurable data:
List
List command name under Telnet interface.
Help
List command name and help information under Telnet interface.
Quit
This command will log out Telnet interface.
Exit
This command will exit the current mode and back to the initial mode.
Reboot
This command will reboot the Industrial Modbus Gateway.