IMG-Series User Manual

User’s Manual of IMG-2x00T Modbus Gateway Series
55
Figure 4-5-14: Router Status Page Screenshot
For example, IP address 192.168.0.60 is set and assigned to serial port 1. As shown below, it will forward directly to serial port 1
when you get a Modbus request that is sent to 192.168.0.60. The Router Setup screen in Figure 4-5-15 appears.
Figure 4-5-15: Router Setup Page Screenshot
The page includes the following fields:
Object Description
• Operation Mode
Used to set Modbus/serial on serial port. The Default is RTU Slave.
 Disable
 RTU Slave,
 RTU Master,
 ASCII Slave
 ASCII Master
• Baud Rate
The rate of data transmission to and from the attached serial device. It allows 50 bps to
921600 bps. The default is 921600 bps.
• Stop Bits
The stop bit follows the data and parity bits in serial communication. It indicates the end
of transmission. The default is 1.
• Data Bits
Indicates the number of the bits in a transmitted data package. The allowed value is
5,6,7,8 and default value is 8.