User's Manual

LoRa Node Controller
LN501 and LN1152
- 14 -
2.2 Hardware Installation
Refer to the illustration and follow the simple steps below to quickly install your LoRa Node.
2.2.1 LoRa Antenna Installation (LN1152)
Step 1: Rotate the antenna into the antenna connector accordingly.
Step 2: The external LoRa antenna should be positioned vertically for a good signal.
2.2.2 Wall Mounting
LN501
Make sure you have a wall mounting bracket, bracket mounting screws, wall plugs, wall mounting
screws and other required tools.
Step 1: Mark the four holes on the wall you prefer to place the device and drill the marked four holes for the wall
plugs (anchors). Then place the mounting bracket over the holes with the wall plugs inside, and tighten it
with the screws.
Step 2: Place the device on the mounting bracket and put the small screw into the hole found on the bottom of the
device and then tighten the screw to finish the job.