User's Manual

LoRa Node Controller
LN501 and LN1152
- 31 -
Object Description
Digital Input
Initial status of counter.
Pull Down: Increase 1 when detecting rising edge
Pull Up/None: Increase 1 when detecting falling edge
Digital Filter
It’s recommended to enable when pulse period is greater than
250 us.
Keep Last Value When Power
Off
Keep the counted values when the device powers off.
Start/Stop
Make the device start/stop counting.
Note: LN501 will send non-changeable counting values if you do
not click“Start”.
Refresh
Refresh to get latest counter values.
Clear
Count the value from 0.
4.3.4 AI Settings
1. Connect analog device to analog input ports on interface 1. If you need LN501 to power the
analog device, connect the power cable of analog device to 5V/9V/12V power output on
interface 1.
2. Go to “General -> AI” of ToolBox software to enable analog input.