MG-11x Series User Manual

User’s Manual of MG-11x Modbus Gateway Series
25
2.2.3 Media Chassis Installation (MG-110/115A)
To install the Modbus Gateway in a 10-inch or 19-inch standard rack, follow the instructions described below.
Step 1: Place your Modbus Gateway on a hard flat surface, with the front panel positioned towards your front side.
Step 2: Carefully slide in the module until it is fully and firmly fitted into the slot of the chassis; the Power LED of the Modbus
Gateway will turn ON.
Figure 3-2: Insert Modbus Gateway into an available slot
2.2.4 Optional DIN-rail Installation
There are two DIN-rail holes on the left side of the Modbus Gateway that allows to be easily installed by DIN-rail mounting.
PLANET optional DIN-rail mounting kit – RKE-DIN -- can be ordered separately. Refer to the following steps for the DIN-rail
mounting of the Modbus Gateway:
Step 1: Screw the DIN rail on the Modbus Gateway
Step 2: Now slide the DIN rail into the track.
Caution
1. Never push the Modbus Gateway
into the slot with force; it could damage the chassis.
2. The Media Converter Chassis supports hot-
swap; there is no need to turn off the
whole chassis before sliding in the new converter.