User's Manual

- 21 -
4-2 Install the 10GBASE-LR/SR XFP Fiber Optic Module MTB-XSR/MTB-XLR
The 10GBASE-LR/SR Fiber Optic module can be installed into Planet products with 10G XFP interface.
Please refer to the following steps to install the 10GBASE-LR/SR Fiber Optic module:
1. Install the XGS3-M24GX or XGS3-S4XG module into the XGS3-42000R; its 10G XFP slot supports
hot swappable feature.
2. Power on the XGS3-42000R L3 Switch and place the
Switch on a at surface. Install the new 10GBASE-LR/SR
Fiber Optic module by inserting it into the slot and sliding
it in until it stops (See Figure 2). Press it rmly until you
hear the module snap into place. Never force, twist or bend
the 10GBASE-LR/SR Fiber Optic module. The 10GBASE-
LR/SR Fiber Optic module slides in smoothly and the
XGS3-42000R L3 Switch will automatically detect the new
module.
1-Port 10G XFP Module
XGS3-XFP
Figure 2: Insert the 10GBASE-LR/
SR Fiber Optic Module
3. After the 10GBASE-LR/SR Fiber connection is made successfully, check the LNK/ACT LED to verify
that if there is a link and a proper connection at the port.
Please refer to the Switch’s user’s manual for more about Switch or module’s management.