User's Manual

Command Guide
136
4.2.65.75 poe pdcheck action
Command:
poe pdcheck action { reboot | alarm | reboot-alarm }
poe Power Over Ethernet.
pdcheck Allows user to enable or disable per port PD Alive Check function.
action Allows user to set which action will be applied if the
PD is without any response
alarm It means system will issue an alarm message via Syslog, SMTP.
reboot It means system will reset the PoE port that is connected to the PD.
reboot-alarm It means system will reset the PoE port and issue an alarm message via Syslog, SMTP.
Default:
N/A
Usage Guide:
To configure PD Ping Alive Check Action of PoE for specific interface
Example:
To configure PD Ping Alive Check Action (Alarm) of PoE for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # poe pdcheck action alarm
4.2.65.76 poe pdcheck enable
Command:
poe pdcheck enable
poe Power Over Ethernet.
pdcheck Allows user to enable or disable per port PD Alive Check function.
enable PD alive check enable.
Default:
Disabled
Usage Guide:
To enable PD Ping Alive Check function of PoE for specific interface.