Quick Guide

5
3. Wiring DC Power Inputs
The6-contactterminalblockconnectorontherearpanelofMGSW-24160Fisused
for two DC redundant powers input. Please follow the steps below to insert the
power wire.
1.Insert positive / negative DC power wires into the contacts 1 and 2 for DC
POWER1,or5and6forDCPOWER2.
2.Tightenthewire-clampscrewsforpreventingthewiresfromloosing.
1 2 3 4 5 6
DC 1
FaultAlarm
DC 2
+ - + -
Note
The wire gauge for the terminal block should be in the range
between12~24AWG.