User's Manual

User’s Manual of MGSW-MGSD Series
 IPv4: The QCE will match only IPV4 frames.
 IPv6: The QCE will match only IPV6 frames.
Displa
ys the OUI field of Source MAC address, i.e. first three octet (byte) of MAC
address.
 SMAC
 DMAC
Specify the type of Destination MAC addresses for incoming frame. Possible
values are:
 Any: All types of Destination MAC addresses are allowed.
 Unicast: Only Unicast MAC addresses are allowed.
 Multicast: Only Multicast MAC addresses are allowed.
 Broadcast: Only Broadcast MAC addresses are allowedd.
The default value is 'Any'.
Indicates (VLAN ID), either a specific VID or range of VIDs.
VID can be in the
range 1-4095 or 'Any'
 VID
Priority
Code Point: Valid value PCP are specific(0, 1, 2, 3, 4, 5, 6, 7) or
range(0-1, 2-3, 4-5, 6-7, 0-3, 4-7) or 'Any'.
 PCP
Drop Elig
ible Indicator: Valid value of DEI can be any of values between 0, 1 or
'Any'.
 DEI
 Action
Indicates the classification action taken on ingress frame if parameters
configured are matched with the frame's content.
There are three action fields: Class, DPL and DSCP.
 Class: Classified QoS Class; if a frame matches the QCE it will be put
in the queue.
 DPL: Drop Precedence Level; if a frame matches the QCE then DP
level will set to value displayed under DPL column.
 DSCP: If a frame matches the QCE then DSCP will be classified with
the value displayed under DSCP column.
 Modification Buttons
You can modify each QCE in the table using the following buttons:
: Inserts a new QCE before the current row.
: Edits the QCE.
: Moves the QCE up the list.
: Moves the QCE down the list.
: Deletes the QCE.
: The lowest plus sign adds a new entry at the bottom of the list of QCL.
217