MGSW-28240F(V3) Datasheet
Data Sheet
1
MGSW-28240F
1
L3 24-Port 100/1000BASE-X SFP + 4-Port 10G SFP+
Metro Ethernet Switch
10Gbps Fiber Ports and Multiple Dual Speed Fiber Ports Deliver High-speed Networking
PLANET MGSW-28240F L3 24-Port 100/1000BASE-X SFP + 4-Port 10G SFP+ Metro
Ethernet Switch is specially designed for service providers and enterprises to deliver
high-speed networking over longer distances. Its SFP ports can be connected to various
fiber and Ethernet cables to extend switching functionality throughout the network.
The MGSW-28240F is capable of providing non-blocking switch fabric and wire-speed
throughput as high as 128Gbps in the temperature range from -10 to 60 degrees C
without any packet loss and cyclic redundancy check (CRC) error. It greatly simplifies
the tasks of upgrading the enterprise LAN for catering to increasing bandwidth demands.
Physical Port
• 24100/1000BASE-XSFPmini-GBIC/SFPports
• 410/100/1000BASE-TRJ45ports, shared with Port-1
to Port-4
• 410GBASE-SR/LRSFP+slots, compatible with
1000BASE-SX/LX/BX SFP
• RJ45 to RS232 DB9 console interface for basic
management and setup
Hardware Conformance
• One 100 to 240V AC or dual 36 to 60V DC power
input, redundant power with polarity reverse protect
function
• 19-inch rack-mountable design
• IP30 metal case
• -10 to 60 degrees C operating temperature
Digital Input and Digital Output
• 2 digital input (DI)
• 2 digital output (DO)
• Integrates sensors into auto alarm system
• Transfers alarm to IP network via email and SNMP
trap
Layer 3 IP Routing Features
• IP dynamic routing protocol supports OSPFv2
• Routing interface provides per VLAN routing mode
• Supports maximum 128 static routes and route
summarization
Layer 2 Features
• Store-and-forwardarchitecturewithrunt/CRCltering
that eliminates erroneous packets to optimize the
network bandwidth
• Storm control support
– Broadcast/Multicast/Unknown unicast
• Supports VLAN
– IEEE 802.1Q tagged VLAN
100~240V AC
50/60 Hz
ON
AC POWER
OFF
DC POWER
ON
OFF
Ring R.O.
FaultFAN2
FAN1
PWR
DC 2
DC 1
DC Input Range:
36V~72V
2 4 6 8 10 12 14 16 18 20 22 24 26 28
272625242322212019181716151413121110987654321 28
Console
Reset
115200, N, 8, 1
Fault
GNDGNDDO 1DO 0DI 1DI 0
DC 2DC 1
1 2 3 4
2 4
MGSW-28240F
AC power input
and power switch
2 x DI&DO
2 x DC power input Console port
Grounding System / PWR / Alarm LED RESET button
DC power switch 4 x 10/100/1000BASE-T
RJ45 port
4 x 1/10GBase-SR/LR
SFP slot
24 x 100/1000BASE-X
SFP slot
Layer 3 Routing Support
The MGSW-28240F enables the administrator to conveniently boost network efficiency
by configuring Layer 3 IPv4/IPv6 VLAN static routing manually, and the IPv4 OSPFv2
(Open Shortest Path First) settings automatically. The OSPF is an interior dynamic
routing protocol for autonomous system based on link state. The protocol creates a
database for link state by exchanging link states among Layer 3 switches, and then uses
the Shortest Path First algorithm to generate a route table based on that database.