Manualshelf

User Manual

ManualsBrandsPLANET Technology ManualsNetworking ComponentsEnterprise-class Universal Network Management Controller
12345678910
7 / 80
Device Setting
Switch: Log in to the Switch’s Web User Interface and refer to the picture below to
enable the SNMP and LLDP function as shown in Figures 1 and 2.
AP: Log in to the AP’s Web User Interface and refer to Figure 3 below to configure the
AP to “Managed AP". Then, click “Apply Change”. To support SNMP AP, enable the
SNMP function.
IP Cam: The ONVIF function is enabled by default.