User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Connecting to the NVR
- Chapter 4. Web-based Management
- Chapter 5. Playback Viewing
- Chapter 6. Event Viewing
- Chapter 7. NVR Setup – Device Configuration
- Chapter 8. NVR Setup -- Channel Configuration
- Chapter 9. NVR Setup -- Event Configuration
- Chapter 10. NVR Setup -- System Operations
- Chapter 11. NVR Local Interface
- 11.1 System Configuration
- 11.1.1 Service
- 11.1.2 Display
- 11.1.3 Network
- 11.1.4 User Account -- User setting
- 11.1.5 User Account -- User Group Setting
- 11.1.6 Disk
- 11.1.7 Channel Configurations -- Adding a Camera (Automatic Search)
- 11.1.8 Channel Configurations -- Adding a Camera (Add manually)
- 11.1.9 E-map
- 11.1.10 Recording
- 11.1.11 Event Setting
- 11.1.12 System Log
- 11.1.13 Maintenance
- 11.1.14 USB Backup
- 11.1 System Configuration
- Appendix A: Ping IP Address
- Appendix B: Planet DDNS Application
- Appendix C: Configuring Port Forwarding Manually
NVR-820 / NVR-1620
Network Video Recorder with HDMI
26
- Audio in
Turn on/off audio of a live video.
- Lens Control
If this camera can control focus and iris, the button of the selection can be active; otherwise, it
will be highlighted. There are three selections of focus and iris as shown below.
- Preset Point Controls
This page focuses on just PTZ camera, and here are some definitions below:
- Add current position: Click this button and current position will be added in the preset point
selection.
- Go to preset point: Select the preset point and the PTZ camera will move to this position.
- Preset point sequence: Click
the preset page will display; user can adjust the preset
point on this page; the other settings will be explained in each chapter.
- Auto pan controls: User can use “right”, “stop”, ”left”, “360 degrees” button to control the
PTZ auto pan function.