User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Connecting to the NVR
- Chapter 4. Web-based Management
- Chapter 5. Playback Viewing
- Chapter 6. Event Viewing
- Chapter 7. NVR Setup – Device Configuration
- Chapter 8. NVR Setup -- Channel Configuration
- Chapter 9. NVR Setup -- Event Configuration
- Chapter 10. NVR Setup -- System Operations
- Chapter 11. NVR Local Interface
- 11.1 System Configuration
- 11.1.1 Service
- 11.1.2 Display
- 11.1.3 Network
- 11.1.4 User Account -- User setting
- 11.1.5 User Account -- User Group Setting
- 11.1.6 Disk
- 11.1.7 Channel Configurations -- Adding a Camera (Automatic Search)
- 11.1.8 Channel Configurations -- Adding a Camera (Add manually)
- 11.1.9 E-map
- 11.1.10 Recording
- 11.1.11 Event Setting
- 11.1.12 System Log
- 11.1.13 Maintenance
- 11.1.14 USB Backup
- 11.1 System Configuration
- Appendix A: Ping IP Address
- Appendix B: Planet DDNS Application
- Appendix C: Configuring Port Forwarding Manually
NVR-820 / NVR-1620
Network Video Recorder with HDMI
43
7.2 Time and Date
Set the time and date by selecting the time zone according to your location. It is imperative that
you set the recorder’s time correctly to avoid the following errors:
• Incorrect display time for playback videos
• Inconsistent display time of event logs and when they actually occur
After selecting the time zone, choose an option below to set the recorder time.
Sync with NTP server – enter the host name or IP address of a valid NTP server and set how
often the recorder should synchronize the time with it by using the “Update interval” drop-down
menu.
• Configure manually – Use the drop-down list and configure the time manually.
• Sync with PC – Check this option to synchronize the recorder time with the PC that you are
currently using to access the recorder.