User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Connecting to the NVR
- Chapter 4. Web-based Management
- Chapter 5. Playback Viewing
- Chapter 6. Event Viewing
- Chapter 7. NVR Setup – Device Configuration
- Chapter 8. NVR Setup -- Channel Configuration
- Chapter 9. NVR Setup -- Event Configuration
- Chapter 10. NVR Setup -- System Operations
- Chapter 11. NVR Local Interface
- 11.1 System Configuration
- 11.1.1 Service
- 11.1.2 Display
- 11.1.3 Network
- 11.1.4 User Account -- User setting
- 11.1.5 User Account -- User Group Setting
- 11.1.6 Disk
- 11.1.7 Channel Configurations -- Adding a Camera (Automatic Search)
- 11.1.8 Channel Configurations -- Adding a Camera (Add manually)
- 11.1.9 E-map
- 11.1.10 Recording
- 11.1.11 Event Setting
- 11.1.12 System Log
- 11.1.13 Maintenance
- 11.1.14 USB Backup
- 11.1 System Configuration
- Appendix A: Ping IP Address
- Appendix B: Planet DDNS Application
- Appendix C: Configuring Port Forwarding Manually
NVR-820 / NVR-1620
Network Video Recorder with HDMI
44
7.3 Storage
Once you install a hard disk to the recorder, you would need to initialize it so that it can be
ready for recording. You can obtain basic information about the disk you installed on this page.
To initialize it, simply choose the “Format” and disk ID under Disk actions and then click
“Apply”.
This page will list the Internal disks and the USB disk only. The HDD will be
formatted in EXT4 file system.
y Disk ID: Display disk ID
y Model: Display HDD model name
y Capacity: Display HDD capacity in “GB”
y Remaining Space: Display remaining space in “GB”
y Online Time: Display when it is formatted
y Recording Period: Display period of recording time that took place
y Establish remaining recording time: Calculate remaining recording time based on
remaining disk space and current camera settings
y Status: Display HDD status