User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Connecting to the NVR
- Chapter 4. Web-based Management
- Chapter 5. Playback Viewing
- Chapter 6. Event Viewing
- Chapter 7. NVR Setup – Device Configuration
- Chapter 8. NVR Setup -- Channel Configuration
- Chapter 9. NVR Setup -- Event Configuration
- Chapter 10. NVR Setup -- System Operations
- Chapter 11. NVR Local Interface
- 11.1 System Configuration
- 11.1.1 Service
- 11.1.2 Display
- 11.1.3 Network
- 11.1.4 User Account -- User setting
- 11.1.5 User Account -- User Group Setting
- 11.1.6 Disk
- 11.1.7 Channel Configurations -- Adding a Camera (Automatic Search)
- 11.1.8 Channel Configurations -- Adding a Camera (Add manually)
- 11.1.9 E-map
- 11.1.10 Recording
- 11.1.11 Event Setting
- 11.1.12 System Log
- 11.1.13 Maintenance
- 11.1.14 USB Backup
- 11.1 System Configuration
- Appendix A: Ping IP Address
- Appendix B: Planet DDNS Application
- Appendix C: Configuring Port Forwarding Manually
NVR-820 / NVR-1620
Network Video Recorder with HDMI
46
7.4.2 Changing the Password of the “Admin” Account
1. Click and highlight the “admin” account in the account list.
2. Its information should be displayed.
3. Enter a new password in the “Password” field and enter it again in “Confirm Password”.
7.4.3 Group Privilege
Group Privilege is where you can create multiple customized access policies for situations if
you need the recorder to be accessed by users other than the administrator. There are 7
pre-defined user groups for privilege configurations. You can do so by creating a group, and
then remove access privileges for certain configuration pages or cameras. Users that are
created and assigned to this group will have limited access instead of full administration rights.
The recorder comes with seven built-in groups and five built-in privilege profiles, except the
“admin” and the “guest” accounts; the other five groups are fully customizable or you can
simply assign a group with one of the default privilege profiles. You can, however, assign more
than one users to the “admin” account if you wish to do so. The guest account comes with a
“view-only” privilege on the “Live View” page, and users in this group do not have the power to
make any changes on the “Live View” page or have access to pages other than the “Live View”
page.
To change a group configuration, after clicking “Add” to add new user account, press “Edit” to
change group privileges.
You can change the group name and privilege.