User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Connecting to the NVR
- Chapter 4. Web-based Management
- Chapter 5. Playback Viewing
- Chapter 6. Event Viewing
- Chapter 7. NVR Setup – Device Configuration
- Chapter 8. NVR Setup -- Channel Configuration
- Chapter 9. NVR Setup -- Event Configuration
- Chapter 10. NVR Setup -- System Operations
- Chapter 11. NVR Local Interface
- 11.1 System Configuration
- 11.1.1 Service
- 11.1.2 Display
- 11.1.3 Network
- 11.1.4 User Account -- User setting
- 11.1.5 User Account -- User Group Setting
- 11.1.6 Disk
- 11.1.7 Channel Configurations -- Adding a Camera (Automatic Search)
- 11.1.8 Channel Configurations -- Adding a Camera (Add manually)
- 11.1.9 E-map
- 11.1.10 Recording
- 11.1.11 Event Setting
- 11.1.12 System Log
- 11.1.13 Maintenance
- 11.1.14 USB Backup
- 11.1 System Configuration
- Appendix A: Ping IP Address
- Appendix B: Planet DDNS Application
- Appendix C: Configuring Port Forwarding Manually
NVR-820 / NVR-1620
Network Video Recorder with HDMI
57
Configurati
Chapter 9. NVR Setup -- Event
on
9.1 Event Sources
The “Event sources” section allows users to define conditions that constitute an event, its
corresponding trigger action and when it will be triggered. Such setting can reduce the
management overhead and notify the administrator only when it’s necessary.
The 1st step is to define the condition to trigger event; we can finish up the event triggers by
setting:
•Which channels will have event trigger function enabled?
•What is considered to be an event?
Define which system events should trigger the recorder to send out notifications.
Use the checkbox to enable event trigger on the desired channels.
* Once motion detection is enabled on this page, please configure the motion
area and enable motion detection in the corresponding channels (cameras) from
camera's own web UI. The NVR only detects the first motion area set in the
camera. The NVR recognizes the first motion area by its ID number set in the
camera.
* Enabling the “From CMS software” option allows the NVR to receive events
from the CMS software and start recording; event such as the intelligent video
detection in the CMS is one example.
You can set up the recorder to receive triggers from a particular camera’s digital input.