User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Connecting to the NVR
- Chapter 4. Web-based Management
- Chapter 5. Playback Viewing
- Chapter 6. Event Viewing
- Chapter 7. NVR Setup – Device Configuration
- Chapter 8. NVR Setup -- Channel Configuration
- Chapter 9. NVR Setup -- Event Configuration
- Chapter 10. NVR Setup -- System Operations
- Chapter 11. NVR Local Interface
- 11.1 System Configuration
- 11.1.1 Service
- 11.1.2 Display
- 11.1.3 Network
- 11.1.4 User Account -- User setting
- 11.1.5 User Account -- User Group Setting
- 11.1.6 Disk
- 11.1.7 Channel Configurations -- Adding a Camera (Automatic Search)
- 11.1.8 Channel Configurations -- Adding a Camera (Add manually)
- 11.1.9 E-map
- 11.1.10 Recording
- 11.1.11 Event Setting
- 11.1.12 System Log
- 11.1.13 Maintenance
- 11.1.14 USB Backup
- 11.1 System Configuration
- Appendix A: Ping IP Address
- Appendix B: Planet DDNS Application
- Appendix C: Configuring Port Forwarding Manually
NVR-820 / NVR-1620
Network Video Recorder with HDMI
93
To add an FTP server,
1. Click "Add" to begin
2. Start by giving a name to the server that you are adding to the recorder
3. Enter the host name or the IP address of the FTP server
4. Enter the communication port of the FTP server (usually port 21)
5. Enter the user name and password of the FTP server if it’s required
6. Check “Use Passive Mode” if it’s required or leave it unchecked to use active mode
7. Click “Test” to verify if all information is entered correctly and the connection to the FTP
server can be established successfully
8. Click “Apply” for the settings to take effect
To add an SMTP server,
1. Enter the host name or the IP address of the SMTP server.
2. Enter the port of the SMTP server.