User's Manual
– 5 – – 6 –
2.2 POE-152, the Injector Installation
1.Connect a standard network cable from Switch/worksta-
tion to “Ethernet” port of POE-152.
2.Connect the long cable that will be used to connect to
theremotedevicetotheport“Ethernet + DC”.
3.Connect the AC adapter to “DC 48V” of POE-152. The
powerLEDwillbesteadyon.
4.Connect with IEEE 802.3af devices, due to the capa-
bility of IEEE 802.3af standard,thePOE-152 can directly
connect with any IEEE 802.3af end-nodes like wireless
access point, VoIP phones and Internet camera where
support IEEE 802.3af In-line Power over Ethernet port.
The screen in Figure 1 appears.
Switch
100 meters
PoE
Power
Data
PoE IP Camera
POE-152
Power
Data
AC
Figure 1: Connection to IEEE 802.3af Device
Once POE-152 detects the existence of an IEEE 802.3af
device, the LED indicator will be steady, ON to shows it is
providingpower.
Note
If the connected device is not fully complying
with IEEE 802.3af standard or in-line power
device, the LED indicator of POE-152 will not
besteadyon.
2.3 POE-152 and POE-152S, the IEEE 802.3af
Injector and Splitter Installation
1.Connect a standard network cable from “Ethernet+DC”
of POE-152 to “Ethernet+DC” of POE-152S. The POE
LEDofPOE-152/POE-152Swilllightoncontinuance.
2.Connect the UTP cable in the package from “Ethernet”
ofPOE-152StotheRJ-45portofremotedevice.
3.Connect properDC plug from“DC OUT” of POE-152S to
remotedevice.
4.Power on the remote device and the LED indicator on
POE-152S will remains on.
Wireless AP
POE-152 POE-152S
Gigabit Switch
100 meters
Figure 2: Connection Architecture over POE-152/152S
Note
1. According to IEEE 802.3af standard, the
POE-152 will not inject power to the cable
ifnotconnectingtoIEEE802.3afdevices.
2. Please ensure the POE-152S output voltage
is correctbeforeapplying power to remote
device.