User's Manual

Once POE-161 detects the existence of an IEEE 802.3at device,

the POE In-use LED indicator will be steady on to shows it is

providing power.

Note

If the connected device is not fully complying with

IEEE 802.3at Power over Ethernet pre-standard or

in-line power device, the LED indicator of POE-161

will not be steady on.

POE-161 and POE-161S, the IEEE 802.3at Injector Splitter

Installation

1. Connect the AC adapter to “DC 56V” of POE-161. The power

LED will be steady on.

2. Connect a standard network cable from

“Ethernet+DC” port

of POE-161 to “PoE In” port of POE-161S. The POE In-use

LED of POE-161 / POE-161S will light on continuance.

3. Connect a standard network cable from Switch/workstation to

“Ethernet” port of POE-161.

4. Connect the UTP cable in the package from

“Ethernet” port

of POE-161S to the RJ-45 port of remote device.

5. Adjust proper DC power output and connect DC plug from

“DC OUT” of POE-161S to remote device.

6. Power on the remote device and its power LED indicator will

remains on.