IEEE 802.
Trademarks Copyright PLANET Technology Corp. 2006. Contents subject to revision without prior notice. PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners. Disclaimer PLANET Technology does not warrant that the hardware will work properly in all environments and applications, and makes no warranty and representation, either implied or expressed, with respect to the quality, performance, merchantability, or fitness for a particular purpose.
TABLE OF CONTENTS 1. INTRODUCTION.......................................................................................................................................... 4 1.1 CHECKLIST ................................................................................................................................................ 4 1.2 ABOUT THE POWER OVER ETHERNET INJECTOR HUB................................................................................... 4 1.3 FEATURES ................................
1. INTRODUCTION 1.1 Checklist Thank you for purchasing our POE-400 IEEE 802.
1.4 Specification Model Ethernet Connector POE-400 8-Port RJ-45 STP with 4-Port "Data" and 4-Port "Data and Power" Ethernet Data rate 10/100Mbps( vary on Ethernet device attached) Input voltage DC 48V, 1.
2. HARDWARE INSTALLATION This product provides two different running speeds – 10Mbps, 100Mbps, in the same device and automatically distinguishes the speed of incoming connection. This section describes the hardware features of POE-400. Before connecting any network device to the POE-400, read this chapter carefully. 2.1. Before Installation Before your installation, it is recommended to check your network environment. If there is any IEEE 802.
2.2 POE-400 and POE-152S, the IEEE 802.3af Injector / Splitter and equipment installation For the places hard to find the power inlet, the POE-400 provide the easiest way to power your Ethernet devices such as PLANET IEEE 802.3af Power over Ethernet Splitter( POE-152S) with Internet Camera (ICA-210 ) or Wireless Access Point (WAP-4060PE) installed in the small office.
3. TROUBLESHOOTING This chapter contains information to help you solve problems. If the Switch is not functioning properly, make sure the Ethernet Switch was set up according to instructions in this manual. How to let my non IEEE 802.3af network devices can work with POE-400? Solution: You can use PLANET Power over Ethernet Splitter, such as PLANET POE-152S to work as a power transformer between POE-400 and non IEEE 802.3af devices.
APPENDIX A NETWORKING CONNECTION A.1 Switch‘s RJ-45 Pin Assignments 10/100Mbps, 10/100Base-TX RJ-45 Connector pin assignment MDI MDI-X Contact Media Dependant Interface Media Dependant Interface -Cross 1 Tx + (transmit) Rx + (receive) 2 Tx - (transmit) Rx - (receive) 3 Rx + (receive) Tx + (transmit) 4, 5 6 7, 8 IEEE 802.3af DC 48V Rx - (receive) Tx - (transmit) IEEE 802.3af DC 0V A.
