SGS-6340 Series Quick Guide

8
6.ConguringIPAddress
The IP address conguration commands for VLAN1 interface are listed below.
Before using in-band management, the Managed Switch must be congured with
an IP address by out-of-band management (i.e. console mode). The conguration
commandsareasfollows:
SGS-6340-48T4S#cong
SGS-6340-48T4S(cong)# interface vlan 1
SGS-6340-48T4S(cong-if-Vlan1)#ip address 192.168.1.254 255.255.255.0
ThepreviouscommandwouldapplythefollowsettingsfortheManagedSwitch.
IPv4 Address: 192.168.1.254
Subnet Mask: 255.255.255.0
Figure 6-1 Conguring IPv4 Address Screen
To check the current IP address or modify a new IP address for the Managed
Switch,pleaseusetheproceduresasfollows:
 Show the current IP address
1.On “SGS-6340-48T4S#” prompt, enter “show ip interface brief”.
2.The screendisplaysthe currentIPaddress, SubnetMask and Gatewayasshown
inFigure6-2.
Figure 6-2 Showing IP Information Screen