Quick Guide

1 Verify the Contents Inside the Package Box
The package should contain the following items plus VGW
series.
Quick Installation Guide x 1 Power Adapter x 1
RJ11 x1 RJ45 x 1
If items are missing or damaged, please contact the seller
immediately.
2 Basic Operation
The VGW series supports basic operation through standard
analog phone set. With an analog phone set, the users can
dial the service codes to maintain their gateway. The service
codes list is shown below:
Service Code Operation Notice
*158# Check LAN port IP address
*159# Check WAN port IP address
*114# Check port account
*115# Check port group account
*160*1# Enable Web access through WAN port
*165*000000#
Restore to factory default values of Web login
Username/Password and WAN/LAN port IP
addresses
*166*000000# Restore to default factory settings
*111# Restart device
3 Basic System Configurations
The VGW series is easy to install by following the steps
below.
Step 1：Connect a computer to a LAN port on the VGW
series. Your PC must be set to 192.168.0.X, the
same domain as that of the VGW series.
Step 2：Start a web browser. To use the user interface, you
need a PC with Internet Explorer (version 8 or
higher), Firefox, or Safari (for Mac).
Step 3：Enter the default IP address of the VGW series:
http://192.168.0.1 into the URL address box.
Step 4：Enter the default user name admin and the default
password admin, and then click Login to enter
Web-based user interface.
Default WAN IP
172.169.0.1
Default Subnet Mask
255.255.0.0
Default Gateway
172.16.0.254
Default LAN IP
192.168.0.1
Default Subnet Mask
255.255.255.0
Default Login User Name
admin
Default Login Password
admin