User's Manual

Enterprise 5-Port 10/100/1000T VPN Security Router
VR-300 series
- 55 -
Chapter 4. Web-based Management
This chapter provides setup details of the device’s Web-based Interface.
4.1 Introduction
The device can be configured with your Web browser. Before configuring, please make sure your PC is
under the same IP segment with the device.
4.2 Logging in to the VPN Router
Refer to the steps below to configure the VPN router:
Step 1. Connect the IT administrator’s PC and VPN router’s LAN port (port 1) to the same hub /
switch, and then launch a browser to link the management interface address which is set to
http://192.168.1.1 by default.
The DHCP server of the VPN router is enabled. Therefore, the
LAN PC will
get IP from the VPN router. If user needs to set IP address of LAN PC
manually, please set the IP address within the range between 192.168.1.2
and 192.168.1.254 inclusively, and assigned the subnet mask of
255.255.255.0.
Step 2. The browser prompts you for the login credentials. (Both are “admin” by default.)
Default IP address: 192.168.1.1
Default user name: admin
Default password: admin
Default SSID (2.4G): PLANET_2.4G
Default SSID (5G): PLANET_5G
The SSIDs are designed for wireless models: VR-300W5, VR-300PW5,
VR-300W6A, VR-300PW6A, VR-300W6, VR-300PW6
Administrators are strongly suggested to change the default admin and
password to ensure system security.