User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Router Management
- Chapter 4. Configuration in Web UI
- Appendix A: Troubleshooting
- Appendix B: Planet Smart Discovery Utility
- Appendix C: Planet DDNS
- Appendix D: Glossary
User’s Manual of WGR-500-4P and WGR-500-4PV
90
4.6.3 Upgrading Firmware
This page provides the firmware upgrade of industrial wall-mount Gigabit router as shown in Figure 4-55.
Figure 4-55: Firmware upgrade
Object
Description
Choose File Press the button to select the firmware.
Upload Press the button upgrades firmware to system.
Reset Press this button to cancel the file.
4.6.4 Reboot
This page enables the device to be rebooted from a remote location. Once the Reboot button is pressed, users
have to re-log in the Web interface for about 60 seconds later as Figure 4-56 is shown below:
Figure 4-56: Reboot
Object
Description
Reboot Press the button to reboot system.
You can also check the SYS LED on the front panel to identify whether the System is loaded
completely or not. If the SYS LED is blinking, then it is in the firmware load stage; if the SYS
LED light is on, you can use the Web browser to log in the industrial wall-mount Gigabit router.