User Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Troubleshooting
- Appendix C: Frequently Asked Questions
User Manual of WNAP-6315
-122-
In AP-1’s WDS Setting, configure AP-2’s MAC address.
Step 4. If you select “Reboot Later”, you can click “Set Security” to continue to configure the encryption and
security key of the WDS connection. Then, click “Apply Changes” to apply the setting.
Step 5. In AP-2, modify the default IP to the same IP range but different from AP-1.
In this case, the IP is changed to 192.168.1.252.