User Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Troubleshooting
- Appendix C: Frequently Asked Questions
User Manual of WNAP-6315
-11-
from “Internal” to “External” via Web UI.
LAN (Passive PoE)
10/100Mbps RJ45 port, auto MDI/ MDI-X & passive PoE supported.
Connect LAN port to the PoE injector to power on the device.
PIN assignment:
Pin 4 VDC+
Pin 5 Reset
Pin 7, 8 VDC-
WAN
10/100Mbps RJ45 port, auto MDI/ MDI-X.
Connect this port to the xDSL modem in gateway mode.
Connect this port to the network equipment in bridge mode.
Reset
Push continually the reset button on the PoE injector about 10 seconds to
reset the configuration parameters to factory defaults.
※ If you have connected with the thunder protector like PLANET
ELA-100, please DO NOT press the reset button on the PoE injector to
prevent the ELA-100 from being damaged. Remove the thunder
protector before pushing the reset button.
Table 2-2 The PoE Injector Indication