User Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: Troubleshooting
- Appendix C: Frequently Asked Questions
User Manual of WNAP-6315
-29-
5.3 TCP/IP Settings
This page is used to configure the parameters for local area network which connects to the LAN port of your AP.
Here you may change the setting for IP address, subnet mask, DHCP, etc.
5.3.1 LAN Interface
On the LAN Settings page, you can configure the IP parameters of the LAN on the screen as shown below.
Figure 5-10 LAN Setting
The page includes the following fields:
Object Description
IP Address The default LAN IP address of the WNAP-6315 is 192.168.1.253. You
can change it according to your request.
Subnet Mask Default is 255.255.255.0. You can change it according to your request.
Default Gateway Default is 192.168.1.253. You can change it according to your request.
DHCP You can select a Disabled, Client, and Server. Default is Disabled,
meaning the WNAP-6315 must connect to a router to assign IP
addresses to clients.
DHCP Client Range For the Server mode, you must enter the DHCP client IP address
range in the field. And you can click the “Show Client” button to show