User Manual

User Manual of WNAP-7206
-126-
 Destination IP
Address
The address of the network or host that you want to assign to a
static route
 Subnet Mask
Determines which portion of an IP address is the network portion,
and which portion is the host portion.
 Default Gateway
The IP address of the default gateway device that allows for the
contact between the Device and the network or host
 Status
 Enable - Select the Enabled in the Status pull-down list to
enable the entry.
 Disable - Select the Disabled in the Status pull-down list to
disable the entry.
 Save
Click the Save button to save the changes.
 Back
Click the Back button to back to the previous page.
 Enable All
Click the Enable All button to enable all entries.
 Disable All
Click the Disable All button to disable all entries.
 Delete All
Click the Delete All button to delete all entries.
5.13 Bandwidth Control
There are two submenus under the Bandwidth Control menu: Control Settings and Rules List. Click any of
them, and you will be able to configure the corresponding function. The detailed explanations for each submenu
are provided below.
5.13.1 Control Settings
Choose menu “Bandwidth Control > Control Settings”, and then you can configure the Egress Bandwidth and
Ingress Bandwidth in the next screen (shown in Figure 5-13-1-1). Their values should be configured less than
1000000Kbps.