User's Manual

– 1 – – 2 –
– 3 – – 4 –
1. Overview
Thank you for purchasing PLANET 150-watt DC power supply.
Power Supply Unit Input Range
XGS-PWR150-DC -36 to -72V DC
Open the box of the Redundant Power Supply unit and carefully
unpack it. The box should contain the following items:
 The DC Power Supply unit x 1
 User’s Manual x 1
If any item is found missing or damaged, please contact your local
reseller for replacement.
2. Introduction
Before installation, please be sure to read this user’s manual
carefully to complete the correct installation of XGS-PWR150-DC
Power Supply Unit. This manual shows how to quickly install the
power in the XGS-6350-24X4C Switch.
The following gure shows the front panel of the XGS-PWR150-DC.
Figure 2-1 XGS-PWR150-DC Front View
3. Installing Redundant Power Supply
Unit
Note
The XGS-PWR150-DC is hot-swappable, so there is
no need to power off the switch before installing or
removing the power supply unit.
Follow these steps to install the redundant power in the switch:
1. Place the Switch on a at surface. Use a screwdriver to unscrew
screws on both sides of the blank plate to remove the blank
plate. Do not discard the blank plate as it can be used again
when removing the power supply unit from the switch.
2
1
1
Figure 3-1 Removing the Blank Plate
2. Install the redundant power by sliding the power supply unit into
the compartment.
1
2
2
Figure 3-2 Sliding the Power Supply Unit into the Compartment
3. Next, tighten the thumbscrews on both sides.
Figure 3-3 Tightening the XGS-PWR150-DC