User Manual

116
Users Manual of XGS-6350-24X4C
7.4.6.2 MAC Binding Configuration
If you click Physical port Config -> Port Security -> MAC bind in the navigation bar, the Configure the
MAC-Binding Info page appears, as shown in figure 9.
Figure 9: MAC binding configuration
Click “Detail” and then you can conduct the binding of the source MAC address for each physical port. In this
way, the MAC address that is allowed to visit the port will be limited.
Figure 10: Setting the binding of the source MAC address
7.4.6.3 Setting the Static MAC Filtration Mode
If you click Physical port Config -> Port Security -> Static MAC filtration mode in the navigation bar, the
Configure the static MAC filtration mode page appears, as shown in figure 11.
Figure 11: Setting the static MAC filtration mode
On this page you can set the static MAC filtration mode. By default, the static MAC filter is disabled. Also, the
static MAC filter mode cannot be set on ports in trunk mode.
7.4.6.4 Static MAC Filtration Entries
If you click Physical port Config -> Port security -> Static MAC filtration entries in the navigation bar, the
Setting the static MAC filtration entries page appears.
Figure 12: Static MAC filtration entry list
If you click “Detail”, you can conduct the binding of the source MAC address for each physical port. According
to the configured static MAC filtration mode, the MAC address of a port can be limited, allowed or forbidden to
visit.
Figure 13: Setting static MAC filtration entries
7.4.6.5 Setting the Dynamic MAC Filtration Mode
If you click Physical port Config -> Port Security -> Dynamic MAC filtration mode in the navigation bar, the
Configure the dynamic MAC filtration mode page appears, as shown in figure 14.