User Manual

157
Users Manual of XGS-6350-24X4C
The storm control mechanism of the port is therefore generated.
Command Purpose
storm-control {broadcast | multicast |
unicast} threshold count
Performs the storm control to the
broadcast/multicast/unicast message.
no storm-control {broadcast |
multicast | unicast} threshold
Cancels the storm control.
Secure Port Configuration
11.2
11.2.1 Overview
You can control the access function of the secure port, enabling the port to run in a certain range according to
your configuration. If you enable the security function of a port through configuring the number of secure MAC
addresses for the port. If the number of secure MAC addresses exceeds the upper limitation and MAC
addresses are insecure, secure port violation occurs. You should take actions according to different violation
modes.
The secure port has the following functions:
 Configuring the number of secure MAC addresses
 Configuring static secure MAC addresses
If the secure port has no static secure MAC address or the number of static secure MAC addresses is
smaller than that of secure MAC addresses, the port will learn dynamic MAC addresses.
 Dropping violated packets when secure port violation occurs
The section describes how to configure the secure port for the switch.
11.2.2 Configuration Task of the Secure Port
 Configuring Secure Port Mode
 Configuring the Static MAC Address of the Secure Port
Configuring the Secure Port
11.3
11.3.1 Configuring the Secure Port Mode
There are two static secure port modes: accept and reject. If it is the accept mode, only the flow whose
source address is same to the local MAC address can be received by the port for communication. If it is the
reject mode, only the flow whose source address is different to the local MAC address can be received by the
port.
Run the following commands in EXEC mode to enable or disable the secure port function:
Command Purpose
configure
Enters the global configuration mode.