User Manual

245
Users Manual of XGS-6350-24X4C
node configuration mode.
Remarks:
The no ether-ring id command is used to delete the node settings and port settings of the Ethernet ring.
26.2.4.2 Configuring the Transit Node
Configure a switch to be the transit node of a ring network according to the following steps:
Command Purpose
Switch#config Enters the switch configuration mode.
Switch_config#ether-ring id
Sets a node and enters the node configuration
mode.
id: Instance ID
Switch_config_ring#control-vlan
vlan-id
Configures the control VLAN.
Vlan-id: ID of the control VLAN
Switch_config_ring#transit-node Configures the node type to be a transit node.
Switch_config_ring#pre-forward-time
value
This step is optional. Configures the time of
maintaining the pre-forward state on the transit
port.
Value: It is a time value ranging from 3 to 30
seconds and the default value is 3 second.
Switch_config_ring#exit Saves the current settings and exits the node
configuration mode.
26.2.4.3 Configuring the Ring Port
Configure a port of a switch to be the port of Ethernet ring according to the following steps:
Command Purpose
Switch#config Enters the switch configuration mode.
Switch_config#interface intf-name
Enters the interface configuration mode.
intf-name: Stands for the name of an interface.
Switch_config_intf#ether-ring id
{primary-port | secondary-port |
transit-port }
Configures the type of the port of Ethernet ring.
ID of the node of Ethernet ring
Switch_config_intf#exit Exits from interface configuration mode.
Remarks:
The no ether-ringidprimary-port { secondary-port | transit-port } command can be used to cancel the port
settings of Ethernet ring.