User Manual

264
Users Manual of XGS-6350-24X4C
Command Purpose
Switch# config
Enters the switch configuration mode.
Switch_config#mether-ring id1 domainid2
Sets a node and enters the node configuration
mode.
id1: instance ID of a node
id2: instance ID of a domain (omitted when it is
0)
Switch_config_ring1#edge-node[assistant-
node]
It is an obligatory step. Sets the node type to be
an edge node.
Switch_config_ring1#sub-ring
This step can be omitted. The edge node must
be the sub-ring node.
Switch_config_ring1#control-vlanvlan-id
It is an obligatory step. Sets the control VLAN
and establishes VLAN “id” and VLAN “id-1”.
vlan-id: ID of the control VLAN
Switch
_config_ring2#single-subring-mode
It is an obligatory step.
You can complete the ring configuration even if
not using this command, but the system cannot
enter the single-ring networking mode. In single
sub-ring networking mode, the channel state of
sub-ring protocol packet is not checked, and
dual-affiliation networking must not exist in the
ring. This command takes effect only on the
edge node and the assistant node.
Switch_config_ring1#pre-forward-timevalu
e
This step is optional. Configures the time of
maintaining the pre-forwarding state of the edge
port.
value: It is a time value ranging from 3 to 30
seconds and the default value is 9 seconds.
Switch_config_ring1#exit
Saves the current settings and exits the node
configuration mode.
Switch_config#
27.2.3.5 Configuring the Ring Port
Configure a port of a switch to be the port of Ethernet ring according to the following steps:
Command Purpose
Switch# config
Enters the switch configuration mode.
Switch_config#interface intf-name
Enters the interface configuration mode.
Switch_config_intf#mether-ring id1
domain id2 primary-port [ secondary-port
Configures the type of the port of Ethernet ring.
id1: instance ID of a node