User Manual

275
Users Manual of XGS-6350-24X4C
Exits from the node configuration mode:
Switch_config_ring4#quit
The following commands are used to set the common port and edge port of node 4:
Switch_config#interface gigaEthernet 0/2
Switch_config_g0/2#mether-ring 4 domain 1 common-port
Switch_config_g0/2#quit
Switch_config#interface gigaEthernet 0/3
Switch_config_g0/3#mether-ring 4 domain 1 edge-port
Switch_config_g0/3#switchport mode trunk
Switch_config_g0/3#quit
Configuring switch S8:
The following commands are used to set the sub-ring transit node, node 4:
Switch_config#mether-ring 4 domain 1
Switch_config_ring4# transit -node
Switch_config_ring4#sub-ring
Switch_config_ring4#control-vlan 2
The following commands are used to set the time related parameters:
Switch_config_ring4#pre-forward-time 12
Exits from the node configuration mode:
Switch_config_ring4#quit
The following commands are used to set the transit port of node 4:
Switch_config#interface gigaEthernet 0/1
Switch_config_g0/1#mether-ring 4 domain 1 transit -port
Switch_config_g0/1#switchport mode trunk
Switch_config_g0/1#quit
Switch_config#interface gigaEthernet 0/2
Switch_config_g0/2#mether-ring 4 domain 1 transit -port
Switch_config_g0/2#switchport mode trunk
Switch_config_g0/2#quit
27.3.4 Unfinished Configurations (to be continued)
 Unfinished basic information configuration: there is one of the ring’s role, the ring’s grade and the
control VLAN unset. One exceptional case is that when a node’s role has configured to be the edge
node or assistant node, the default ring's grade is sub-ring.
 Contradiction of basic information: When a node’s role is edge-node or assistant-node, the default
ring's grade is sub-ring; when the ring’s grade is major-ring, prompt information will appear.
 Sub ring having no corresponding major-ring node: When a node’s role is edge-node or assistant-node,
this node is borne on the major-ring node; if there is no corresponding major-ring node to compulsorily