User Manual

318
Users Manual of XGS-6350-24X4C
show ethernet oam statistics {pdu |
link-monitor | remote-failure}
interface [intf-type intf-id]
Displays the OAM statistics information on all
interfaces or a designated interface.
 The pdu parameter is used to classify and
count the OAM packets according to the
code-domain value of the OAM packet.
 The link-monitor parameter is used to display
the detailed statistics information of normal link
events.
 The remote-failure parameter is to display the
detailed statistics information about the remote
trouble.
show ethernet oam configuration
interface [intf-type intf-id]
Displays the OAM configuration information on all
interfaces or a designated interface.
show ethernet oam runtime interface
[intf-type intf-id]
Displays the OAM running information on all
interfaces or a designated interface.
33.1.4 Configuration Example
33.1.4.1 Network Environment Requirements
You need configure the OAM protocol on the interface where two managed switches connect for capturing the
information about managed switch receiving error frames on user access side.
33.1.4.2 Network Topology
Figure 2 Network topology
33.1.4.3 Configuration Procedure
Configuring switch A:
Switch_config_g0/1#ethernet oam
Switch_config_g0/1#ethernet oam mode passive
Switch_config_g0/1#ethernet oam link-monitor frame threshold low 10
Switch_config_g0/1#ethernet oam link-monitor frame window 30
Switch_config_g0/1#show ethernet oam configuration int g0/1
GigaEthernet0/1
General
-------