User Manual

Users Manual of XGS-6350-24X4C

Step 1: Place the Managed Switch on a hard flat surface, with the front panel positioned towards the front

side.

Step 2: Attach the rack-mount bracket to each side of the Managed Switch with supplied screws attached to

the package.

You must use the screws supplied with

the mounting brackets. Damage caused to the

parts by using incorrect screws would invalidate the warranty.

Step 3: Secure the brackets tightly.

Step 4: Follow the same steps to attach the second bracket to the opposite side.

Step 5: After the brackets are attached to the Managed Switch, use suitable screws to securely attach the

brackets to the rack.

Step 6: Proceeds with Steps 4 and 5 of session 2.2.1 Desktop Installation to connect the network cabling and

supply power to the Managed Switch.

2.2.3 Installing the SFP/SFP+/QSFP28 100G SFP Transceiver

The sections describe how to insert an SFP/SFP+/QSFP28 100G SFP transceiver into an

SFP/SFP+/QSFP28 100G SFP slot. The SFP/SFP+/QSFP28 100G SFP transceivers are hot-pluggable and

hot-swappable. You can plug in and out the transceiver to/from any SFP/SFP+/QSFP28 100G SFP port

without having to power down the Managed Switch, as Figure 2-4 shows.

Figure 2-4 Plug in the SFP transceiver

 Approved PLANET SFP/SFP+/QSFP28 100G SFP Transceivers

PLANET Managed Switch supports both single mode and multi-mode SFP/SFP+/QSFP28 100G SFP