User Manual
34
Users Manual of XGS-6350-24X4C
10Gbps SFP+ (10G Ethernet/10GBASE)
Model Speed (Mbps)
Connector
Interface
Fiber Mode Distance Wavelength (nm)
Operating Temp.
MTB-SR 10G LC Multi Mode Up to 300m
850nm 0 ~ 60 degrees C
MTB-LR 10G LC Single Mode 10km 1310nm 0 ~ 60 degrees C
10Gbps SFP+ (10GBASE-BX, Single Fiber Bi-directional SFP)
Model Speed (Mbps)
Connector
Interface
Fiber Mode
Distance
Wavelength (TX)
Wavelength (RX)
Operating Temp.
MTB-LA20
MTB-LB20
10G WDM(LC)
Single Mode
20km
1270nm 1330nm 0 ~ 60 degrees C
10G WDM(LC)
Single Mode
20km
1330nm 1270nm 0 ~ 60 degrees C
MTB-LA40
MTB-LB40
10G WDM(LC)
Single Mode
40km
1270nm 1330nm 0 ~ 60 degrees C
10G WDM(LC)
Single Mode
40km
1330nm 1270nm 0 ~ 60 degrees C
MTB-LA60
MTB-LB60
10G WDM(LC)
Single Mode
60km
1270nm 1330nm 0 ~ 60 degrees C
10G WDM(LC)
Single Mode
60km
1330nm 1270nm 0 ~ 60 degrees C
100Gbps QSFP28 SFP (100G Ethernet/100GBASE)
Model Speed (Mbps)
Connector
Interface
Fiber Mode Distance Wavelength (nm)
Operating Temp.
QSFP-100G-SR4
100G MPO Multi Mode Up to 100m
850nm 0 ~ 70 degrees C
QSFP-100G-LR4
100G LC Single Mode 10km 1310nm 0 ~ 70 degrees C
It is recommended to use PLANET SFP/SFP+/QSFP28 100G SFP on the Managed Switch.
If you insert an SFP/SFP+/QSFP28 100G SFP transceiver that is not supported, the
Managed Switch will not recognize it.
1. Before we connect theXGS-6350-24X4C to the other network device, we have to make sure both sides
of the SFP transceivers are with the same media type, for example: 1000BASE-SX to 1000BASE-SX,
1000BASE-LX to 1000BASE-LX.
2. Check whether the fiber-optic cable type matches with the SFP transceiver requirement.
To connect to 1000BASE-SX SFP transceiver, please use the multi-mode fiber cable with one side
being the male duplex LC connector type.
To connect to 1000BASE-LX SFP transceiver, please use the single-mode fiber cable with one side
being the male duplex LC connector type.
Connect the Fiber Cable
1. Insert the duplex LC connector into the SFP/SFP+transceiver.
2. Connect the other end of the cable to a device with SFP/SFP+ transceiver installed.
3. Check the LNK/ACT LED of the SFP/SFP+ slot on the front of the Managed Switch. Ensure that the