User Manual

544
Users Manual of XGS-6350-24X4C
When planning the address pool, pay attention that the service addresses cannot be the same as those in the
address pool; note that the address number in the address pool cannot be smaller than the maximum number
of member switches in the cluster (including the command switch).
57.3.2 Creating Cluster
A. Activating command switch
Run the following command in global configuration mode to set the current switch to the command switch:
Command Description
cluster mode
commandercluster-name
Sets the current switch to the command
switch.
B. Activating standby switch
Run the following command in global configuration mode to set the current switch to the standby switch:
Command Description
cluster mode commander
member
Sets the current switch to the standby
switch.
C. Adding member switch
Run the following command in global configuration mode to add the standby switch with the designated MAC
address to the cluster:
Command Description
cluster member [idmember-id]
mac-addressH.H.H [password
enable-password]
Adds member switch.
57.3.3 Configuring Cluster
A. Configuring IP pool
Run the following command in global configuration mode to configure the IP address pool for cluster
management:
Command Description
cluster address-pool A.B.C.D
A.B.C.D
Configures the IP address pool.
B. Configuring hellotime
You can modify the interval to send the handshake message between the command switch and the member
switch by configuring hellotime (unit: second).
Run the following command in global configuration mode to configure the cluster’s hellotime:
Command Description