User Manual

59
Users Manual of XGS-6350-24X4C
snmp-server trap-source
interface
Specifies the source interface where traps
originate and sets the source IP address for
the message.
snmp-server queue-length
length
Creates the queue length of the message for
each host that has traps.
Default value: 10
snmp-server
trap-timeoutseconds
Defines the frequency to resend traps in the
resending queue.
Default value: 30 seconds
g) Configuring the SNMP binding source address
Run the following command in the global configuration mode to set the source address for the SNMP
message.
Command Function
snmp source-addr ipaddress
Sets the source address for the SNMP
message.
h) Configuring SNMPv3 group
Run the following command to configure a group.
Command Function
snmp-server group [groupname {v1
| v2c |v3 [auth | noauth |
priv]}][readreadview][writewriteview]
[notifynotifyview]
[accessaccess-list]
Configures a SNMPv3 group. You can only
read all items in the subtree of the Internet by
default.
i) Configuring SNMPv3 user
You can run the following command to configure a local user. When an administrator logs in to a device,
he has to user the username and password that are configured on the device. The security level of a
user must be higher than or equals to that of the group which the user belongs to. Otherwise, the user
cannot pass authentication.
Command Function
snmp-server user username
groupname {v1 | v2c | v3
[encrypted] [auth {md5 | sha}
auth-password ]} [access
access-list]
Configures a local SNMPv3 user.
You can run the following command to configure a remote user. When a device requires to send traps to a